JUKI SC-320 - How to Remove the Control Box

1) How to remove the control box
(l) Remove the 2 screws O on control
box O in Fig. 4-21 with a screwdriver.
@ Remove screw ® in the front cover of
the PSC box, and openfront cover O .
Remove connector 0 of the control box
which has been connected to the J60
(SC-120/-220) or the J61 (SC-320) mounted
on main circuit board 0 Then, remove
cable © of the control box from rubber
bush O. Finally,pull out the cable through
the hole in the table according to the wiring
route, and remove the control box.
45 -
•JUKI
Fig. 4-21
a
Fig. 4-22
Fig. 4-23
From the library of: Superior Sewing Machine & Supply LLC