JUKI SC-510 - II. SET-UP; III. FOR THE OPERATOR; IV. MAINTENANCE

To Next Page

To Previous Page

CONTENTS

. SPECIFICATIONS

..................................................................................... 1

. SET-UP

...................................................................................................... 1

1. Installing the motor unit ...........................................................................................1

2. Installing the control box ..........................................................................................1

3. Installing the belt .......................................................................................................2

4. Adjusting the pulley cover ........................................................................................2

Installation and adjustment for the protecting pin and the belt slip-off preventing

bracket ................................................................................................................................. 3

Connecting the cords ...............................................................................................4

7. Attaching the connecting rod .................................................................................10

. FOR THE OPERATOR

............................................................................ 11

1. Operation of SC-510 ................................................................................................11

2. Explanation of the operation panel .......................................................................13

3. Setting for functions of SC-510 ..............................................................................18

4. Function setting list ................................................................................................20

5. Detailed explanation of selection of functions .....................................................24

6. Automatic compensation of neutral point of the pedal sensor .........................37

7. Setting of the auto lifter function ...........................................................................37

8. Initialization of the setting data ..............................................................................38

. MAINTENANCE

...................................................................................... 38

1. Replacing the fuse ..................................................................................................38

2. Changing procedure between 100V to 120V and 200V to 240V

(Possible only for the voltage changeover type) .................................................40

3. Error codes ..............................................................................................................41

Other manuals for JUKI SC-510