7. Attaching the connecting rod
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and a lapse of 5 minutes or more.
6) Insert connector
4
of the power source cord to the connector (top) of the control box.
(Caution) Securely insert the connector while paying attention to the direction.
7) Securely x power source cover
5
supplied with the unit as accessories to power source cover installing
plate
2
with two screws
6
supplied with the unit as accessories while being careful that the cord is not
caught by the cover.
* For handling the cable, refer to 14) and 15) of “6. Connecting the cords”.
1) Fix connecting rod
1
to installing hole
B
of
pedal lever
2
with nut
3
.
2) Installing connecting rod
1
to installing hole
A
will lengthen the pedal depressing stroke, and
the pedal operation at a medium speed will be
easier.
1
2
B
A
3
5
4
6
To Next Page
Loading...
