JUKI SC-810 - Page 21

– 15 –
ENGLISH
1 2
1 2 3 4
5
1 2 3 4
5
4) When you want to advance the setting No., press
/ switch
2
to advance the setting No.
When you want to return the setting No., press
/ switch
1
to return the setting No.
(Caution) When
/
switch
1
(
/
switch
2
) is held pressing, the setting No. will re-
turn (will advance) continuously.
When the setting No. is advanced (re-
turned), the contents which are before by
one (after by one) will be determined. So,
be careful when changing the contents (
up/down switch is touched).
5) When the change has been completed, press
/ switch
1
or / switch
2
to
specify the changed value.
(Caution) 1. When turning OFF the power before
performing this work, the contents
which have been changed are not up-
dated.
2. Press
/
switch
1
, and screen
display will change to the contents of
the setting No. which is before by one.
3. Press
/
switch
2
, and screen
display will change to the contents of
next setting No. After completing the
operation, turn OFF the power and turn
ON the power again to return to the
normal operation.
After completing the operation, turn OFF the power
and turn ON the power again to return to the normal
operation.
SpeciedNo.
EXAMPLE) CHANGING THE FLICKER REDUC-
ING FUNCTION (SETTING No. 5)
Press
/ switch
2
several times to adjust set
No. to “5”. Press switch
5
three times to change the
set No. to “3” since the current set value is displayed
on LED
4
. (Standard : “0”)
(Caution) Keep pressing switch
4
or
switch
3
, and the setting value can be
changed continuously.
* Simultaneously press switch
3
and switch
4
, and the setting contents of set No. will return to
the initial value.