– 43 –
ENGLISH
@8
Function added to the needle up / down compensating switch (Function setting No. 93)
Operation of needle up/down compensating switch is changed after turning ON the power or thread trimming.
0 : Normal (needle up/down compensating stitching only)
1 : One stitch compensating stitching is performed only when aforemen-
tioned changeover is made. (Upper stop / upper stop)
2 : Needle-down function operates after thread trimming.
3 : Function of needle-down with operation of 2 plus presser lowering op-
eration and needle-up with thread trimming operation is added.
#0
Setting of max. number of rotation of the sewing machine head (Function setting No. 96)
This function can set the max. number of rotation of the sewing machine head you desire to use.
Upper limit of the set value varies in accordance with the sewing machine head to be connected.
150 to Max sti/min < 50 sti/min >
#1
Main shaft reference angle compensation (Function setting No. 120)
Main shaft reference angle is compensated
Setting range – 60 to 60˚ < 1˚ >
#2
UP position starting angle compensation (Function setting No. 121)
Angle to detect UP position starting is compensated.
Setting range – 15 to 15˚ < 1˚ >
#3
DOWN position starting angle compensation (Function setting No. 122)
Angle to detect DOWN position starting is compensated.
Setting range – 15 to 15˚ < 1˚ >
@9
Continuous stitching + one shot stitching nonstop function (Function setting No. 94)
This function is used to proceed a step to the next one without stopping the sewing machine at the end
of the step when performing sewing with the continuous sewing and one-shot sewing combined using the
programming function of the operation panel IP.
0 : Normal (Stop when a step has completed.)
1 : The sewing machine proceeds to next step without stopping after a
step has completed.
9 4 0
9 3 0
21 0 0
21 1 0
21 2 0
9 6 003 0
21 4 0
#4
Setting of energy saving function during standby (Function setting No. 124)
It is possible to reduce power consumption while the sewing machine is in standby state. It should be noted
that the startup of the sewing machine may delay for a moment if this function is set.
0 : Energy-saving mode is ineffective.
1 : Energy-saving mode is effective.
41 4 0
41 6 0
#5
Number of stitches setting for automatic cancellation of alternate up/down output (function set-
ting No. 144)
Alternate up/down output is cancelled when the set number of stitches has been sewn (0: Automatic can-
cellation is disabled). After the alternate up/down output is output by the set number of stitches, output is
turned OFF. When "0" is set, this function does not work. (However, the number of stitches actually sewn
may be larger than the set one according to the sewing speed.)
0 : Automatic cancellation is disabled
1 to 30 stitches
#6
Selection of alternate up/down output after thread trimming (function setting No. 146)
Alternate up/down output is forcibly turned ON or OFF after thread trimming.
When this function is set to disable, the alternate up/down output retains the state before thread trimming.
When the set value is "1," the alternate up/down output is brought into the OFF state. When the set value
is "2," the output is brought into the ON state.
0 : Disabled
1 : OFF
2 : ON
To Next Page
Loading...
