– 44 –
#7
Selection of alternate up/down initial output (function setting No. 147)
Alternate up/down output is forcibly turned ON or OFF when the power is turned ON.
When this function is set to disable, the alternate up/down output is restored to the state in which the func-
tion has been set before the last turn-OFF of the power.
When the set value is "1," the alternate up/down output is brought into the OFF state. When the set value
is "2," the output is brought into the ON state.
0 : Disabled
1 : OFF
2 : ON
#8
2-pitch output during reverse feed stitching at the beginning/end of sewing (function setting No. 148)
2-pitch output is set in the ON state during control of reverse feed stitching at the beginning/end of sewing.
0 : The function is in the OFF state
1 : The function is in the ON state
#9
2-pitch output inversion during alternate up/down output (function setting No. 149)
The 2-pitch output status is output with inverted in synchronism with the alternate up/down output.
2-pitch output is changed over to "OFF" if it is set in the ON state or to "ON" if it is set in the OFF state
when changing over the alternate up/down output.
0: The function is in the OFF state
1: The function is in the ON state
$0
2-pitch initial output selection (function setting No. 150)
2-pitch output is forcibly turned ON or OFF when the power is turned ON.
When this function is set to disable, the 2-pitch output is restored to the state in which the function has
been set before the last turn-OFF of the power.
When the set value is "1," the alternate up/down output is brought into the OFF state. When the set value
is "2," the output is brought into the ON state.
0 : Disabled
1 : OFF
2 : ON
41 7 0
41 8 0
41 9 0
51 0 0
$1
Pause and stitch alignment function (function setting No. 151)
When the reverse feed stitching/multi-layer stitching is specied, the sewing machine temporarily stops at
every corner of the sewing pattern at the beginning and end of sewing and during overlapped stitching.
(Caution) When this function is brought into ON state, functions setting numbers 51 to 53 are disabled.
0 : The function is in the OFF state
1 : The function is in the ON state
$2
Condensation stitching function for beginning/end of sewing (function setting No. 154)
In the case of the sewing machine head provided with the condensation stitching function, the sewing ma-
chine performs condensation stitching instead of automatic reverse feed stitching.
This function should be used when you do not want to carry out reverse feed stitching but want to prevent
thread from slipping off the material at the beginning and end of sewing.
0 : The function is in the OFF state
1 : The function is in the ON state
$3
Needle thread grasping function (function setting No. 156)
Selection between enable/disable of the needle thread grasping function
0 : Enable/disable is changed over with the operation enabling switch
1 : The function is disabled
2 : The function is enabled.
51 1 0
51 4 0
51 6 0
Temporarily
stops at these
points.
To Next Page
Loading...
