What to do if the excess temperature value lies below the working temperature setpoint in Julabo EH Laboratory Equipment?
If the excess temperature value is lower than the working temperature setpoint on your Julabo Laboratory Equipment, you should set the excess temperature to a higher value.
What to do if Julabo Laboratory Equipment is operated without bath fluid?
If the Julabo Laboratory Equipment circulator is operated without bath fluid, or the liquid level is too low, you should replenish the bath tank with the bath fluid.
What to do if tube breakage has occurred in Julabo Laboratory Equipment?
If tube breakage occurs in your Julabo Laboratory Equipment, indicated by an insufficient filling level due to excessive bath fluid pumped out, replace the tubing and replenish the bath tank with the bath fluid.
What to do if a short-circuit is registered during the self-test of Julabo Laboratory Equipment?
If, during the self-test after switch-on, a short-circuit is registered between pin 2 and pin 4 of the control cable, or the control cable is interrupted during operation of your Julabo Laboratory Equipment, reconnect the cable or eliminate the short-circuit.
Covers handling, maintenance, power supply, electromagnetic environment, ambient conditions, and protection.
Details safety installations (IEC 61010), environmental conditions, protection class, and interference resistance.
Explains warning symbols, signal words, and provides essential safety recommendations for operating the unit.
Details how to securely mount the immersion circulator, ensuring proper placement and electrical safety.
Provides guidance on selecting appropriate bath fluids, detailing properties of water and recommended fluids.
Provides crucial safety instructions for connecting the unit to a power source.
Details the procedure for switching the unit on, starting operation, and stopping the circulator.
Guides on how to set and change the desired temperature setpoint for the circulator.
Details the procedure for calibrating the temperature sensor for accurate readings.
Details the excess temperature and low liquid level protection systems and their settings.
Lists specific error codes and their corresponding causes, such as low fluid, short circuits, or sensor defects.
Defines the warranty period (2 years/10,000 hours) and conditions for material and workmanship defects.
General| Pump Flow Rate | 15 l/min |
|---|---|
| Type | Heating Circulator |
| Heating Capacity | 2.0 kW |
| Pump Capacity | 15 L/min |
| Power Supply | 230V/50Hz |
To Next Page
