Julabo EH - Operating Procedures; Power Connection; Switching On and Off

Operating procedures
18
6. Operating procedures
6.1. Power connection
Caution:
• Only connect the unit to a power socket with earthing contact (PE –
protective earth)!
• The power supply plug serves as safe disconnecting device from the line and
must be always easily accessible.
• Never operate equipment with damaged mains power cables.
• Regularly check the mains power cables for material defects (e.g. for cracks).
• We disclaim all liability for damage caused by incorrect line voltages!
Check to make sure that the line voltage matches the supply voltage
specified on the identification plate.
6.2. Switching on / Start - Stop
• Switching on:
Turn the unit on with the mains power switch. (1).
L The unit performs a self-test. A few segments of the 4-digit LED
temperature DISPLAY will illuminate.
The display "OFF" indicates the unit is ready to operate
(standby mode).
Start:
• Press the
key for about 4 seconds.
The LED temperature DISPLAY indicates the actual bath
temperature.
Stop:
• Press the
key for about 4 seconds.
• Turn the unit off with the mains power switch.