Julabo FL601 - 7.3. Filling

28
7.3. Filling
Top view
Push
Push
Filling level indicator (13)
H
L
Take care that no liquid enters the interior of the circulating
cooler.
 Connect the tubing from the external system to the pump
connectors and check for leaks
Respect instructions from page 20 to page 23!
 Check to make sure that the drain tap (8) is closed.
 Unlock and open lid of fill in opening (4) by slightly pushing.
 Fill in tempering fluid up to marking „H“ of the filling level
indicator.
 Turn the mains switch (1) on
(Switching on - see page 29).
 Switch on unit. To do so press button for approx. 4
seconds.
 Tempering fluid is pumped into the externally connected
system.
Refill fluid up to marking „H“.
 The recirculating cooler is ready for operation.