Julabo FL601 - 11.3. List of Commands

40
11.3. List of commands
out commands: Setting parameters or temperature values.
Command Parameter Response of recirculating cooler
out_mode_05 0 Stop the unit = R –OFF-.
out_mode_05 1
Start the unit.
out_sp_00 xxx.xx
Set working temperature
in commands: Asking for parameters or temperature values to be displayed.
Command Parameter Response of recirculating cooler
version none Number of software version (V X.xx)
status none
Status message, error message (see page 41 )
in_pv_00 none Actual bath temperature.
in_sp_00 none Working temperature
in_mode_05 none
Recirculating cooler in Stop/Start condition:
0 = Stop
1 = Start