4 Operation
24
4.2 Language selection
After switching on the device for the first time, the user can either confirm the flashing displayed lan-
guage with "OK" or select another language using the "Up"/"Down" buttons and then confirm this with
"OK".
If, at a later point, another user is to also have the option of selecting a language, the configuration pa-
rameter "Language selection active" must be set to "Yes" (Configuration > System data). After applying
the language, this parameter is automatically set to "No", so that language selection is not necessary the
next time the device is switched on.
The language of the device texts can be changed at any time in the configuration settings (regardless of
language selection after switch-on).
4.3 Further information
For further information regarding the operation and configuration of the device, see the operating man-
ual, as well as the interface description (Modbus) and the ST editor manual, if necessary.
1.9 "Available technical documentation", page 9
To Next Page
Loading...
Need help?
General
