English 1
1 Introduction
1.1 Explanation of symbols
1.2 Hardware / software requirements
The following hardware / software requirements must be met for the installa-
tion and operation of the setup program for PC:
Minimum
configuration
- IBM-PC or compatible PC from 386 processor upwards
- 4Mbytes main memory
- 3.5" disk drive
-mouse
- one free serial interface
- 6Mbytes available on hard disk
- VGA graphics 800x600
- Microsoft Windows
1
3.11/95/98/NT4.0
In addition, the following items are necessary for the communication between
the PC and the instrument:
- PC interface cable
- adapter for PC interface cable
A
Caution
This symbol is used when there may be damage to equipment or data if the
instructions are disregarded or not followed accurately.
H
Note
This symbol is used when your special attention is drawn to a remark.
h
Action
This symbol indicates that an action to be performed is described.
The individual steps are marked by this asterisk, e. g.
h switch off supply
h pull terminal strip off the module
1. Microsoft and Windows are registered trademarks
of the Microsoft Corporation
To Next Page
Loading...
