JUNCTEK
and Celsius, and then press the 【OK】button to confirm the change.
5). Preset battery capacity: 0000.0Ah
In the system settings interface, press the【▲】【▼】buttons to switch to the
preset battery capacity setting. Press the
【
OK
】
button, and the cursor will
select the value. Press the 【▲】【▼】 buttons to change the value, and press
the
【
OK
】
button to switch between digits from the smallest to the largest.
When the highest digit is selected, press the
【
OK
】
button again to confirm
and save the rated battery capacity value.
6). Remaining capacity percentage: 100%
In the system settings interface, press the 【▲】【▼】buttons to switch to the
remaining capacity percentage setting. Press the
【
OK
】
button, and the cursor
will select the value. Press the 【▲】【▼】buttons to change the value, and
press the 【OK】button again to confirm and set the percentage of the current
battery capacity to the preset battery capacity. You can set the current battery
capacity based on actual usage. The current capacity percentage can be
continuously adjusted from 0% to 100%.
7). Daytime screen brightness: 0-100%, default brightness 80%, default time
(6:00-22:00) .When adjusting the daytime screen brightness time, the
nighttime screen brightness time will also change accordingly. For
example, if the daytime screen brightness time is changed to (7:00-20:00),
the nighttime screen brightness time will automatically become
(20:00-7:00).
8). Nighttime screen brightness: 0-100%, default brightness 30%, default time
(22:00-6:00) When adjusting the nighttime screen brightness time, the
daytime screen brightness time will also change accordingly.
(2). System Settings-Page 2:
Figure 3-1-2 System Settings - Page 2
9). Screen-off time
0 indicates the screen is always on, while setting 1-60 seconds means the
screen will turn off after no operation for the specified time (regardless of
whether there is current or not). Press any key to wake up the screen. (I=0 and
time>20s) means that the current is 0 and lasts for 20 seconds, the screen will
To Next Page
Loading...
General