JUNCTEK
recovery time setting. Press the 【OK】 button briefly to select the value with
the cursor. Use the 【▲】【▼】 buttons to change the value, then press the
【
OK
】
button again to confirm the recovery time setting.
When the value is set to 00s, the protection status will last until the 【OK】
button is pressed in the main interface to release the protection status. If the
value is greater than 00s, for example, if the recovery time is set to 5s, it
means that after the value returns to normal and lasts for 5s, the instrument
will automatically cancel the protection status, close the circuit, and start
working.
The protection function requires the purchase of a separate relay. If a
relay is not equipped, do not set this value, and install a relay in the
circuit before it can act as a protective device to disconnect the circuit.
(4). System Settings-Page 4:
Figure 3-1-4 System Settings - Page 4
25).Display host mode (Display screen communication)
In the system settings interface, press the
【
▲
】【
▼
】
keys to switch to the
display host mode. Short press the
【
OK
】
key to select open or close with the
cursor. Use the
【
▲
】【
▼
】
keys to switch, and press the
【
OK
】
key again to
confirm whether to turn on or off the display screen communication. It is
necessary to turn on the display screen communication function when using
communication protocol communication. (After turning off the display screen
communication function, the display module will not update data
automatically.)
26).Factory reset: Confirm
In the system settings interface, press the
【
▲
】【
▼
】
keys to switch to the
factory reset. After a short press of the
【
OK
】
button, a pop-up window for
restoring factory settings will appear. You can select to confirm or cancel the
factory reset with the
【
▲
】【
▼
】
keys. When "Confirm" is selected with the
cursor, press the
【
OK
】
key. If the display shows "Success", the factory reset is
completed.
To Next Page
Loading...
General