EasyManuals Logo

JUNCTEK KH-F Series User Manual

JUNCTEK KH-F Series
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
JUNCTEK
21
The protection function requires the purchase of an additional relay. If
no relay is installed, do not set this value. Install the relay in the circuit to
enable the protection function and cut off the circuit when necessary.
21).Over power protection: 0-12000.00W/48000.00W/72000.00W (depending
on the machine model)
In the system settings interface, press the buttons to switch to the
power protection setting. Short press the OK button to select the value.
Press the
buttons to change the value, and press the
OK
button
to switch the digit from the smallest to the highest. When the highest digit is
reached, press theOKbutton again to confirm the power protection setting.
If the value is 00000.00W, the protection function is not activated. If the value
is greater than 00000.00W, the protection function is activated. If the current
power is greater than the set power protection value, OPP will be displayed in
the upper left corner of the screen, indicating that the protection is active.
The protection function requires the purchase of an additional relay. If no
relay is installed, do not set this value. Install the relay in the circuit to
enable the protection function and cut off the circuit when necessary.
22).Over temperature protection: -20-120
/-4-248
In the system settings interface, press the buttons to switch to the
over temperature protection setting. Short press theOKbutton to select the
value. Press the
buttons to change the value, and press the
OK
button again to confirm the over temperature protection setting.
If the value is ---, the protection function is not activated. If the current
ambient temperature exceeds the set over temperature protection value, OTP
will be displayed in the upper left corner of the screen, indicating that the
protection is active. The protection function requires the purchase of an
additional relay. If no relay is installed, do not set this value. Install the
relay in the circuit to enable the protection function and cut off the circuit
when necessary.
23).Low temperature protection: -20-120/-4-248
In the system settings interface, press the
buttons to switch to the
low temperature protection setting. Press the
OK
button briefly to select the
value, then press the buttons to change the value. Press the OK
button again to confirm the low temperature protection setting.
If the value is set to ---
, the protection function is not enabled. If the current
ambient temperature exceeds the set low temperature protection value, the
screen will display LTP in the upper left corner, indicating that the device is in
protection mode.
The protection function requires the purchase of a relay separately. If the
relay is not equipped, do not set this value, and install the relay in the
circuit before the protection function can be used to disconnect the
circuit.
24).Recovery time: 0-99s
In the system setting interface, press the buttons to switch to the

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JUNCTEK KH-F Series and is the answer not in the manual?

JUNCTEK KH-F Series Specifications

General IconGeneral
BrandJUNCTEK
ModelKH-F Series
CategoryMonitor
LanguageEnglish