83
08.11 EN
NOTE
Loads must not be deposited on travel or escape routes, in front of safety
mechanisms or operating equipment that must be accessible at all times.
Transporting load units
Requirements
– Load unit correctly lifted.
– Load handler lowered for transport (approx. 150 - 200 mm above the ground).
– Mast tilted back fully.
Procedure
• Accelerate and decelerate gradually.
• Adapt your travel speed to the conditions of the route and the load you are
transporting.
• Watch out for other traffic at crossings and passageways.
• Always travel with a lookout at blind spots.
• On slopes and inclines always carry the load facing uphill, never approach at an
angle or turn.
Depositing load units
Requirements
– Warehouse location suitable for storing the load.
Procedure
• Set the mast vertical.
• Drive carefully up to the storage location.
• Carefully lower the load handler so that the forks are clear of the load.
Z Avoid depositing the load to avoid damaging the load and the load handler.
• Lower the load handler.
• Carefully remove the forks from the pallet.
The load unit is lowered.
To Next Page
Loading...
