To Next Page

To Previous Page

1007.GB

E 8

4.2 Travel, steering, braking

Be extremely careful when driving and steering, especially when operating outside

the geometry of the truck.

The electric steering system is self-monitoring.

The steering controller monitors the fault frequency over a certain period. If the same

fault is detected several times during this period, the steering controller reduces the

travel speed of the truck to slow travel. If such a fault occurs, the travel speed is not

reset to normal travel by switching the truck off and on again. This prevents a fault

being cancelled without being rectified.

As the steering system is a safety-critical component, the fault must be rectified by

the manufacturer's service department.

Emergency Disconnect

– Push the isolator (1) down

All electrical functions are deactivated.

Driver platform switch

The platform (15) must be occupied for all travel functions to work.

If the truck is fitted with “pedestrian operation” (o), the following functions can be

carried out (depending on the configuration) without standing on the platform (15):

– Travelling at a speed of approximately 4 km/h in forward (V) or reverse (R) direction

by applying the controller (6).

– Slow speed travel (approx. 2km/h) (see section 4.3) by pressing the “Pedestrian”

button (8, 10) (o).