To Next Page

To Previous Page

E 33

1007.GB

9.1 Operating hours display

Hourmeter: The hourmeter (30) contained in the battery discharge indicator shows

the overall travel and lifting times. The meter starts as soon as the operator stands on

the operator platform or uses pedestrian mode.

Display range between 0.0 and 99,999.0 hours. Travel and lifting are logged. This is

a backlit display.

Error messages

The operating hours display is also used for indicating errors. The error is displayed

in two parts, starting with a “C” for component and a three-digit component number,

followed by an “E” for error with alternating three-digit error number.

If several errors occurs at the same time, they are displayed one after the other. The

errors are displayed for as long as they remain (always in combination Cxxx / Exxx).

Error messages overwrite the service hour display. Most errors cause the emergency

stop to be triggered. Errors remain displayed until the control circuit is switched off

(Code lock).

The manufacturer’s service department has detailed component descriptions with

error codes.

Display for parameter changes (travel programs)

The LC display (30) is used in conjunction with the operator keypad (CANCODE (o))

to display the setting parameters. The first three digits of the display show the

parameter numbers, the last three digits indicate the parameter setting.

Settings of parameter group 0XX (code lock) are not displayed.

9.2 Power up test

On power up the display shows:

– the software version of the display instrument (briefly),

– the operating hours

– the charge status