8.9.1 Activating the keypad
Procedure
• Release the emergency disconnect
switch, see page 80.
• Enter the default code 1-2-3-4
using the keys below the display
unit (55).
The truck is switched on.
• Press the key below the "Settings"
symbol (93).
• Press the key below the "Change
set-up code" symbol (94).
• Enter the set-up code 2-4-1-2 using
the keypad (60).
The set-up code entered is
displayed.
Z
When starting the truck for the first
time, change the set-up code. The
new set-up code must not be the
same as the default set-up code or
an access code.
Press the key below the "Delete"
symbol (95).
The set-up code is deleted.
• Enter the new set-up code using
the keypad (60).
• Press the key below the "Confirm"
symbol (96).
The new set-up code is displayed.
Z
If the new set-up code was entered
incorrectly, the procedure can be
repeated using the key below the
"Delete" symbol (95).
• To return to the main menu, press
the key below the "Back"
symbol (97).
• Delete the default code, see page 161.
• Create access codes, see page 160.
The keypad is active.
151
04.19 en-GB
To Next Page
Loading...
Need help?
General
