What to do if my Juniper Network Router has active alarms?
To address active alarms on your Juniper Network Router: * First, check the system LED on the front panel. A steady green light indicates normal operation without alarms. * If the LED is not green, use the `show chassis alarms` command to check the router's status and identify any specific issues.
General| Model | ACX1100 |
|---|---|
| Operating System | Junos OS |
| Form Factor | 1U |
| Operating Temperature | 0°C to 45°C |
| Input Voltage | 100 to 240 VAC |
| Operating Relative Humidity | 10% to 90% (non-condensing) |
| Forwarding Modes | Store and Forward |
| Power Supply | AC power supply |
Guides on how to connect the router to power sources (AC/DC).
Steps for initial router configuration using CLI commands.
Provides resources and methods for troubleshooting router hardware issues.
Information on how to contact Juniper Networks Technical Assistance Center (JTAC).
General safety guidelines and warnings for Juniper Networks devices.
Safety guidelines and warnings specific to equipment installation.
Guidelines and warnings related to electrical safety.
To Next Page
