To Next Page

To Previous Page

NOTE: We no longer include a DB-9 to RJ-45 cable or a DB-9 to RJ-45 adapter with a CAT5E copper cable as

part of the device package. If you require a console cable, you can order it separately with the part number JNP-

CBL-RJ45-DB9 (DB-9 to RJ-45 adapter with a CAT5E copper cable).

What Else Do I Need?

• Someone to help you secure the router to the rack

• A number 2 Phillips (+) screwdriver

• An electrostac discharge (ESD) grounding strap

• A management host such as a laptop or desktop PC

• A serial-to-USB adapter (if your laptop or desktop PC doesn’t have a serial port)

• A grounding cable: 14-10 AWG (2-5.3 mm²), stranded wire, or as permied by the local code, with a Panduit

LCD10-10A-L or equivalent lug aached

• Two #10-32 screws to secure the grounding lug

CAUTION: Ensure that a licensed electrician has aached the appropriate grounding lug to your

grounding cable. Using a grounding cable with an incorrectly aached lug can damage the router.

Install the ACX7100-48L in a Rack

Here’s how to install the ACX7100-48L in a four-post rack:

1. Review the General Safety Guidelines and Warnings.

2. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other end to a site

ESD point.

3. Decide which end of the router you want to place at the front of the rack. Posion the router so that the AIR IN labels

are facing the cold aisle, or the AIR OUT labels are facing the hot aisle.

4. Aach the mounng rails to the sides of the router using the 12 at head screws.

5. Li the router and posion it in the rack. Line up the boom hole in each mounng rail with a hole in each rack rail,

making sure the router is level.

Juniper ACX7100 User Manual

Questions and Answers: