Juniper Day One Plus SRX380 - Page 3

•
Someone to help you screw the SRX380 into the rack
•
Eight rack mount screws
•
A number two Phillips (+) screwdriver
Install the SRX380 in a Rack
Before you begin the installation, review General Safety Guidelines and Warnings.
Here’s how to install the SRX380 in a rack:
1. Review General Safety Guidelines and Warnings
2. Wrap and fasten one end of the electrostatic discharge (ESD) grounding strap around your bare wrist, and connect the
other end to a site ESD point.
3. Attach the mounting brackets to the side mounting rails using the six flat-head mounting screws.
g100945
1
2
12
2—1— Mounting railMounting bracket
4. Attach the mounting rails to the sides of the SRX380 using the M4x6-mm Phillips flat-head mounting screws.
g100946
5. Lift the SRX380 and position it in the rack. Line up the bottom hole in each mounting bracket with a hole in each rack
rail, making sure the SRX380 is level.
3