Juniper E Series

JUNOSe 7.2.x Policy Management Configuration Guide
106 ! Bandwidth Management
host1(config-subif)#exit
host1(config)#
Example 2: Multiple
Traffic Flows
In the following example, interface ATM 3/1.1 again classifies on three traffic flows;
however, this policy rate limits the aggregate of the three flows to 1 MB.
host1(config)#ip classifier-list clFlowAll ip host 10.1.1.1 any
host1(config)#ip classifier-list clFlowAll ip host 10.1.1.2 any
host1(config)#ip classifier-list clFlowAll ip host 10.1.1.3 any
host1(config)#ip policy-list plRateLimit
host1(config-policy-list)#classifier-group clFlowAll
host1(config-policy-list-classifier-group)#exit
host1(config-policy-list)#exit
host1(config)#interface atm 3/1.1
host1(config-subif)#ip policy input plRateLimit statistics enabled
host1(config-subif)#exit
host1(config)#