Juniper E Series Configuration Guide

JUNOSe 7.2.x Policy Management Configuration Guide
22 ! Creating Policy Lists
ATM policy input polUbr
Statistics are disabled
1 interface(s) found
host1#show atm subinterface atm 0/0.101
Circuit Interface
Interface ATM-Prot VCD VPI VCI Type Encap MTU Status Type
----------- -------- --- --- --- ------- ----- ---- ------ ---------
ATM 0/0.101 RFC-1483 101 0 101 PVC SNAP 9180 up Static
Auto configure status : static
Auto configure interface(s) : none
Detected 1483 encapsulation : none
Detected dynamic interface : none
Interface types in lockout : none
Assigned profile (IP) : none assigned
Assigned profile (BridgedEnet): none assigned
Assigned profile (PPP) : none assigned
Assigned profile (PPPoE) : none assigned
Assigned profile (any) : none assigned
SNMP trap link-status: disabled
InPackets: 0
InBytes: 0
OutPackets: 0
OutBytes: 0
InErrors: 0
OutErrors: 0
InPacketDiscards: 0
InPacketsUnknownProtocol: 0
OutDiscards: 0
ATM policy input polCbr
classifier-group *
3096 packets, 377678 bytes
traffic-class best-effort
color green
1 interface(s) found
Creating a Policy List for IP
The following example creates an IP policy list named routeForABCCorp. For
information about creating the CLACLs and rate-limit profile used in this example,
see the previous sections.
1. Create the policy list routeForABCCorp.
host1(config)#ip policy-list routeForABCCorp
host1(config-policy-list)#
2. Create the classification group for the CLACL named ipCLACL10 and assign the
precedence to the classification group.
host1(config-policy-list)#classifier-group ipCLACL10 precedence 75
host1(config-policy-list-classifier-group)#
NOTE: Commands that you issue in Policy Configuration mode do not take effect
until you exit from that mode.

Juniper E Series Specifications

General

Brand	Juniper
Model	E Series
Category	Network Router
Language	English