Policy Management show Commands ! 133
Chapter 5: Monitoring Policy Management
Now display baselined statistics:
host1#show ip interface atm 9/1.1 delta
Partial results might be:
Policy output 2egress
classifier-group claclWst10 entry 1
10 packets, 1280 bytes
forward
show ipv6 interface
! Use to display detailed or summary information, including policy and classifier
information, for a particular IPv6 interface or for all interfaces.
! The default for the show ipv6 interface command is all interface types and all
interfaces.
! Use the brief or detail keywords with the show ipv6 interface command to
display different levels of information.
! Field descriptions
! Description—Optional description for the interface or address specified
! Network Protocols—Network protocols configured on this interface
! Link local address—Local IPv6 address of this interface
! Internet address—External address of this interface
! Operational MTU—Value of the MTU
! Administrative MTU—Value of the MTU if it has been administratively
overridden using the configuration
! Operational speed—Speed of the interface
! Administrative speed—Value of the speed if it has been administratively
overridden using the configuration
! Creation type—Method by which the interface was created (static or
dynamic)
! ND reachable time—Amount of time (in milliseconds) that the neighbor is
expected to remain reachable
! ND duplicate address detection attempts—Number of times that the router
attempts to determine a duplicate address
! ND neighbor solicitation retransmission interval—Amount of time (in
milliseconds) during which the router retransmits neighbor solicitations
! ND proxy—Whether the router replies to solicitations on behalf of a known
neighbor, enabled or disabled
! ND RA source link layer—Whether the RA includes the link layer
! ND RA interval—Amount of time (in seconds) of the neighbor discovery
router advertisement
! ND RA lifetime—Amount of time (in seconds) of the neighbor discovery
router advertisement
To Next Page
Loading...
