Juniper E Series

JUNOSe 7.2.x Policy Management Configuration Guide
136 ! Policy Management show Commands
Conformed: 0 packets, 0 bytes
Exceeded: 0 packets, 0 bytes
IPv6 policy output ipv6PolOut2
rate-limit-profile RlpOutA classifier-group clgB entry 1
Committed: 0 packets, 0 bytes
Conformed: 0 packets, 0 bytes
Exceeded: 0 packets, 0 bytes
rate-limit-profile RlpOutB
Committed: 0 packets, 0 bytes
Conformed: 0 packets, 0 bytes
Exceeded: 0 packets, 0 bytes
IPv6 policy local-input ipv6PolLocIn5
rate-limit-profile Rlp1Mb classifier-group clgC entry 1
Committed: 0 packets, 0 bytes
Conformed: 0 packets, 0 bytes
Exceeded: 0 packets, 0 bytes
rate-limit-profile Rlp5Mb
Committed: 0 packets, 0 bytes
Conformed: 0 packets, 0 bytes
Exceeded: 0 packets, 0 bytes
queue 0: traffic class best-effort, bound to ipv6 FastEthernet9/0.6
Queue length 0 bytes
Forwarded packets 0, bytes 0
Dropped committed packets 0, bytes 0
Dropped conformed packets 0, bytes 0
Dropped exceeded packets 0, bytes 0
show mpls l2transport interface
! Use to display status and configuration information about layer 2 services over
MPLS (also known as Martini, or layer 2 transport) on the router or on specific
interfaces. Displays only layer 2 circuits for the specified interface.
! Field descriptions
! Interface—Specifier and status of each interface
! base-LSP/remote-addr—Identifies either the tunnel that is selected to
forward the traffic or the address of the router at the other end
! group-id—Group ID number for the interface
! vc-id—VC ID number for the interface
! mtu—Maximum transmission unit for the interface
! state/in/out-label—Status of the Layer 2-over-MPLS connection or the
incoming/outgoing VC label
! Mpls Statistics
" pkts—Number of packets received or sent
" hcPkts—Number of high-capacity (64-bit) packets received or sent
" octets—Number of octets received or sent
" hcOctets—Number of high-capacity (64-bit) octets received or sent
" errors—Number of packets that are dropped for some reason at receipt
or before being sent
" discardPkts—Number of packets that are discarded due to lack of
buffer space at receipt or before being sent