Juniper E Series

JUNOSe 7.2.x Policy Management Configuration Guide
10 ! Creating Classifier Control Lists
frame-relay classifier-list
! Use to create or modify a Frame Relay classifier control list.
! Use the following keywords to configure the list:
! traffic-class—Matches packets with a class that you defined using the
traffic-class command
! color
" green—Matches packets with color green, indicating a low drop
preference
" yellow—Matches packets with color yellow, indicating a medium drop
preference
" red—Matches packets with color red, indicating a high drop preference
! user-packet-class—Matches packets with the specified user packet class
value
! de-bit—Matches Frame Relay packets with the specified DE bit value,
either 0 or 1
! Example
host1(config)#frame-relay classifier-list frclassifier color red user-packet-class 10
de-bit 1
! Use the no version to remove the classifier control list.
gre-tunnel classifier-list
! Use to create or modify a GRE tunnel classifier control list.
! Use the following keywords to configure the list:
! traffic-class—Matches traffic with a class that you defined using the
traffic-class command
! color
" green—Matches packets with color green, indicating a low drop
preference
" yellow—Matches packets with color yellow, indicating a medium drop
preference
" red—Matches packets with color red, indicating a high drop preference
NOTE: Do not use the asterisk (*) for the name of a classifier list. The asterisk is
used as a wildcard for the classifier-group command.
NOTE: Do not use the asterisk (*) for the name of a classifier list. The asterisk is
used as a wildcard for the classifier-group command.