To Next Page

To Previous Page

JUNOSe 7.2.x Policy Management Configuration Guide

18 ! Creating Classifier Control Lists

l2tp classifier-list

! Use to create or modify an L2TP classifier control list.

! Use the following keywords to configure the list:

! traffic-class—Matches packets with a traffic class that you defined using

the traffic-class command

! color

" green—Matches packets with color green, indicating a low drop

preference

" yellow—Matches packets with color yellow, indicating a medium drop

preference

" red—Matches packets with color red, indicating a high drop preference

! user-packet-class—Matches packets with the specified user packet class

! Example

host1(config)#l2tp classifier-list l2tpclassifier color red user-packet-class 7

! Use the no version to remove the classifier control list.

mpls classifier-list

! Use to create or modify an MPLS classifier control list.

! Use the following keywords to configure the list:

! traffic-class—Matches packets with a traffic class that you defined using

the traffic-class command

! color

" green—Matches packets with color green, indicating a low drop

preference

" yellow—Matches packets with color yellow, indicating a medium drop

preference

" red—Matches packets with color red, indicating a high drop preference

! user-packet-class—Matches packets with the specified user packet class

! exp-bits—Specifies the value of the EXP bit to match in the range 0–7

! exp-mask—Specifies the mask applied to the EXP bits in the range 1–7

! Example

host1(config)#mpls classifier-list mplsClass user-packet-class 10 exp-bits 3

exp-mask 5

! Use the no version to remove the classifier control list.

NOTE: Do not use the asterisk (*) for the name of a classifier list. The asterisk is

used as a wildcard for the classifier-group command.

NOTE: Do not use the asterisk (*) for the name of a classifier list. The asterisk is

used as a wildcard for the classifier-group command.

Juniper E Series Configuration Guide

Other manuals for Juniper E Series