Juniper EX4100

5. Enter conguraon mode.
{master:0} root> configure
{master:0}[edit]
root#
6. Delete the ZTP conguraon. Factory default conguraons can vary over dierent releases. You may see a
message that the statement does not exist. Don’t worry, it’s safe to proceed.
{master:0}[edit]
root# delete chassis auto-image-upgrade
7. Add a password to the root administraon user account. Enter a plain-text password, an encrypted password, or an
SSH public key string. In this example, we show you how to enter a plain-text password.
{master:0}[edit]
root# set system root-authentication plain-text-password
New password: password
Retype new password: password
8. Acvate the current conguraon to stop ZTP messages on the console.
{master:0}[edit]
root# commit
configuration check succeeds
commit complete
9. Congure the hostname.
{master:0}[edit]
root# set system host-name name
10. Congure the IP address and prex length for the management interface on the switch. As part of this step, you
remove the factory default DHCP seng for the management interface.
{master:0}[edit]
root# delete interfaces vme unit 0 family inet dhcp
root# set interfaces vme unit 0 family inet address address/prefix-length
12