exp-swap-push-push default;
ieee-802.1 (rewrite-name | default) <vlan-tag (outer | outer-and-inner)>;
ieee-802.1ad (rewrite-name | default) <vlan-tag (outer | outer-and-inner)>;
inet-precedence (rewrite-name | default) <protocol mpls>;
}
scheduler-map map-name;
shaping-rate bps;
translation-table (to-dscp-from-dscp | to-dscp-ipv6-from-dscp-ipv6 |
to-exp-from-exp | to-inet-precedence-from-inet-precedence) table-name;
}
}
interface-set interface-set-name {
excess-bandwith-share (equal | proportional value);
input-excess-bandwith-share (equal | proportional value);
input-traffic-control-profile profile-name;
input-traffic-control-profile-remaining profile-name;
internal-node;
output-traffic-control-profile profile-name;
output-traffic-control-profile-remaining profile-name;
}
}
}
Related
Documentation
Notational Conventions Used in Junos OS Configuration Hierarchies•
[edit firewall] Hierarchy Level
Several statements in the [edit firewall] hierarchy are valid at numerous locations within
the hierarchy. To make the complete hierarchy easier to read, the repeated statements
are listed in the following sections, which are referenced at the appropriate locations in
“Complete [edit firewall] Hierarchy” on page 38.
•
Common Firewall Actions on page 33
•
Common IP Firewall Actions on page 34
•
Common IPv4 Firewall Actions on page 34
•
Common IP Firewall Match Conditions on page 35
•
Common IPv4 Firewall Match Conditions on page 36
•
Common Layer 2 Firewall Match Conditions on page 36
•
Complete [edit firewall] Hierarchy on page 38
Common Firewall Actions
This section lists statements that are valid at the following hierarchy levels, and is
referenced at those levels in “Complete [edit firewall] Hierarchy” on page 38 instead of
the statements being repeated.
•
[edit firewall family (any | ccc | ethernet-switching | inet | inet6 | mpls | vpls) filter
filter-name term term-name then]
•
[edit firewall filter filter-name term term-name then]
33Copyright © 2013, Juniper Networks, Inc.
Chapter 4: Configuration Statements