Juniper EX9200 Series

adjust-minimum rate;
delay-buffer-rate (bps | cps cps | percent percentage);
excess-rate (percent percentage | proportion value);
guaranteed-rate (bps | percent percentage) <burst-size bytes>;
overhead-accounting (frame-mode | cell-mode) <bytes byte-value>;
scheduler-map map-name;
shaping-rate (bps | percent percentage) <burst-size bytes>;
}
}
tri-color;
}
class-of-service {
interfaces {
interface-name {
excess-bandwith-share (equal | proportional value);
input-excess-bandwith-share (equal | proportional value);
input-scheduler-map map-name;
input-shaping-rate bps;
input-traffic-control-profile profile-name;
output-forwarding-class-map map-name;
output-traffic-control-profile profile-name;
scheduler-map map-name;
scheduler-map-chassis (map-name | derived);
shaping-rate bps;
unit (logical-unit-number | *){
classifiers {
dscp (classifier-name | default) {
family [ inet mpls ];
}
dscp-ipv6 (classifier-name | default) {
family [ inet mpls ];
}
exp (classifier-name | default);
ieee-208.1 (classifier-name | default) <vlan-tag (inner | outer)>;
ieee-208.1ad (classifier-name | default);
inet-precedence (classifier-name | default);
}
forwarding-class class-name;
input-scheduler-map map-name;
input-shaping-rate bps;
input-traffic-control-profile profile-name shared-instance instance-name;
loss-priority-maps {
(map-name | default);
}
loss-priority-rewrites {
(map-name | default);
}
output-forwarding-class-map map-name;
output-traffic-control-profile profile-name shared-instance instance-name;
rewrite-rules {
dscp (rule-name | default) <protocol mpls>;
dscp-ipv6 (rule-name | default);
exp (rule-name | default) <protocol [ mpls-any | mpls-inet-both |
mpls-inet-both-non-vpn ]>;
exp-push-push-push default;
Copyright © 2013, Juniper Networks, Inc.32
Class of Service Overview and Examples for EX9200 Switches