Juniper J-Series Administration Guide

Table 77: Summary of Key RPM Output Fields (continued)
Additional InformationValuesField
Cumulative Jitter for a Probe
The Services Router maintains records of the most
recent 50 probes for each configured test. These 50
probes are used to generate RPM statistics for a
particular test.
Total number of probes used for the data set.Samples
System time when the first probe in the sample was
received.
Earliest
Sample
System time when the last probe in the sample was
received.
Latest
Sample
Average jitter for the 50–probe sample.Mean Value
Standard deviation of the jitter values for the
50–probe sample.
Standard
Deviation
Smallest jitter value, as measured over the 50–probe
sample.
Lowest
Value
System time when the lowest value in the 50–probe
sample was received.
Time of
Lowest
Sample
Highest jitter value, as measured over the 50–probe
sample.
Highest
Value
System time when the highest jitter value in the
50–probe sample was received.
Time of
Highest
Sample
Monitoring PPP
PPP monitoring information includes PPP address pool information, session status
for PPP interfaces, cumulative statistics for all PPP interfaces, and a summary of PPP
sessions.
NOTE: PPP monitoring information is available only in the CLI. The J-Web interface
does not include pages for displaying PPP monitoring information.
To display PPP monitoring information, enter the following CLI commands:
■
show ppp address-pool pool-name
■
show ppp interface interface-name
■
show ppp statistics
■
show ppp summary
Using the Monitoring Tools ■ 147
Chapter 7: Monitoring the Router and Routing Operations

Juniper J-Series Specifications

General

Brand	Juniper
Model	J-Series
Category	Network Router
Language	English