Juniper J-Series Administration Guide

Table 102: CLI Request System Halt Command Options (continued)
DescriptionOption
Time at which to stop the software processes on the router. You can specify time in
one of the following ways:
■
now—Stops the software processes immediately. This is the default.
■
+minutes—Stops the software processes in the number of minutes from now that
you specify.
■
yymmddhhmm—Stops the software processes at the absolute time you specify.
Enter the year, month, day, hour (in 24-hour format), and minute.
■
hh:mm—Stops the software processes at the absolute time that you specify, on
the current day. Enter the time in 24-hour format, using a colon (:) to separate
hours from minutes.
at time
Specifies the number of minutes from now to stop the software processes on the router.
This option is a synonym for the at +minutes option.
in minutes
Specifies the boot device to boot the router from after the halt:
■
compact-flash—Reboots from the internal compact flash. This is the default.
■
removable-compact-flash—Reboots from the optional external compact flash. This
option is available on J2320, J2350, J4300, and J6300 Services Routers only.
■
usb—Reboots from the USB storage device.
media type
Provides a message to display to all system users before the software processes on the
router are stopped.
message "text"
Rebooting or Halting a Services Router ■ 197
Chapter 10: Performing Software Upgrades and Reboots

Juniper J-Series Specifications

General

Brand	Juniper
Model	J-Series
Category	Network Router
Language	English