user@host# set encrypt-configuration-files
7. To begin the encryption process, commit the configuration.
user@host# commit
commit complete
Decrypting Configuration Files
To disable the encryption of configuration files on a Services Router and make them
readable to all:
1. Enter operational mode in the CLI.
2. To verify your permission to decrypt configuration files on this router, enter the
following command and the encryption key for the router:
user@host> request system set-encryption-key
Enter EEPROM stored encryption key:
Verifying EEPROM stored encryption key:
3. At the second prompt, reenter the encryption key.
4. Enter configuration mode in the CLI.
5. To enable configuration file decryption, enter the following commands:
user@host# edit system
user@host# set no-encrypt-configuration-files
6. To begin the decryption process, commit the configuration.
user@host# commit
commit complete
Modifying the Encryption Key
When you modify the encryption key, the configuration files are decrypted and then
reencrypted with the new encryption key.
Encrypting and Decrypting Configuration Files â– 205
Chapter 11: Managing Files
To Next Page
Loading...
Need help?
General
