Juniper JUNOS 10.1 - RELEASE NOTES REV 4

version version
Routing Engine 0 RE BIOS 0 1.5 1.7 OK
Routing Engine 0 RE BIOS Backup 1 1.5 1.7 OK
Perform indicated firmware upgrade ? [yes,no] (no) yes
Firmware upgrade initiated.
2.
Monitor the status of upgrade using the show system firmware command.
root> show system firmware
Part Type Tag Current Available Status
version version
Routing Engine 0 RE BIOS 0 1.5 1.7 PROGRAMMING
Routing Engine 0 RE BIOS Backup 1 1.5 1.7 OK
Routing Engine 0 RE FPGA 11 12.3.0 OK
root> show system firmware
Part Type Tag Current Available Status
version version
Routing Engine 0 RE BIOS 0 1.5 1.7 UPGRADED
SUCCESSFULLY
Routing Engine 0 RE BIOS Backup 1 1.5 1.7 OK
Routing Engine 0 RE FPGA 11 12.3.0 OK
NOTE: The device must be rebooted for the upgraded active BIOS to take effect.
Backup BIOS:
1.
Initiate the upgrade using the request system firmware upgade re bios backup
command.
root> request system firmware upgrade re bios backup
Part Type Tag Current Available Status
version version
Routing Engine 0 RE BIOS 0 1.5 1.7 OK
Routing Engine 0 RE BIOS Backup 1 1.5 1.7 OK
Perform indicated firmware upgrade ? [yes,no] (no) yes
Firmware upgrade initiated.
2.
Monitor the status of upgrade using the show system firmware command.
root> show system firmware
Part Type Tag Current Available Status
version version
Routing Engine 0 RE BIOS 0 1.5 1.7 OK
New Features in JUNOS Release 10.1 for SRX Series Services Gateways and J Series Services Routers ■ 119
New Features in JUNOS Release 10.1 for SRX Series Services Gateways and J Series Services Routers