EasyManuals Logo

Juniper JUNOS 10.1 - RELEASE NOTES REV 4 User Manual

Juniper JUNOS 10.1 - RELEASE NOTES REV 4
205 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #163 background imageLoading...
Page #163 background image
AX411 Access Point
On AX411 Access Points, an access point would not synchronize with the newly
associated configuration (by changing or swapping the MAC address) and also
would not join the changed cluster when it was associated to a new config block
in the WLAN access point configuration.
[PR/504581: This issue has been resolved.]
Chassis Cluster
On SRX240 and SRX650 devices in chassis cluster active/active preempt mode,
after the primary node reboot and preempt failover, the RSTP session broke and
the common ALGS like RSH, TALK, PPTP, MSRPC, RTSP, SUNRPC, and SQL also
broke. [PR/448870: This issue has been resolved.]
On SRX5600 devices with an active/active chassis cluster configuration, the
memory might corrupt when the memory pointers of the appid module could
be inappropriately assigned under stress conditions. [PR/483522: This issue has
been resolved.]
Flow and Processing
On an SRX5800 device with a 1-Gbps IOC, when more than 10 ports per port
module were used, intermittent packet loss occurred because of oversubscription
and you had to reboot the SRX5800 device. [PR/433209: This issue has been
resolved]
Hardware
On SRX650 devices, the 16-port Gigabit Ethernet switch GPIM was incorrectly
labeled as XGPIM. This switch, which is a double-high XPIM, operates only in
slots 2 to 4 or 6 to 8, connecting to the 20-gigabit connector in slots 2 or 6,
respectively. [PR/444511: This issue has been resolved.]
Integrated Convergence Services
When originating and terminating the alternate sides, the consecutive G.711
faxes passed between two FXS ports failed. [PR/465775: This issue has been
resolved.]
Interfaces and Routing
On J2320 devices, when the DHCP client was enabled, the default route was not
added to the route table. [PR/296469: This issue has been resolved.]
On SRX240 devices, drops in out-of-profile LLQ packets would be seen in the
presence of data traffic, even when the combined (data+LLQ) traffic did not
oversubscribe the multilink bundle. [PR/417474: This issue has been resolved.]
Issues in JUNOS Release 10.1 for SRX Series Services Gateways and J Series Services Routers 163
Issues in JUNOS Release 10.1 for SRX Series Services Gateways and J Series Services Routers

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper JUNOS 10.1 - RELEASE NOTES REV 4 and is the answer not in the manual?

Juniper JUNOS 10.1 - RELEASE NOTES REV 4 Specifications

General IconGeneral
BrandJuniper
ModelJUNOS 10.1 - RELEASE NOTES REV 4
CategorySoftware
LanguageEnglish

Related product manuals