Juniper JUNOS 10.1 - RELEASE NOTES REV 4 User Manual

■ user-vlan-id
■ user-vlan-id-except
■ VPLS flood FTF and input FTF
■ Simple filters
■ Filter action 'then ipsec-sa'
■ Filter action 'then next-hop-group'
■ Mac-filter output accounting and output policing
[PR/466990]
■ When a firewall loopback filter exists and the default term is discard, the multicast
forwarding cache entries will be created since the resolve request is dropped at
the Packet Forwarding Engine level. As a workaround, add an additional term
to accept the multicast destination address 224/4. [PR/531787]
Routing Protocols
■ When you configure damping globally and use the import policy to prevent
damping for specific routes, and a new route is received from a peer with the
local interface address as the next hop, the route is added to the routing table
with default damping parameters, even though the import policy has a non-default
setting. As a result, damping settings do not change appropriately when the route
attributes change. [PR/51975]
■
When you issue the show ldp traffic-statistics command, the following system
log message might be generated for all forwarding equivalence classes (FECs)
with an ingress counter set to zero: "send rnhstats GET: error: ENOENT — Item
not found." [PR/67647]
■ If ICMP tunneling is enabled on the router and you configure a new logical system
that does not have ICMP tunneling enabled, the feature is globally disabled.
[PR/81884]
■
The keepalive timeout counter for multicast sessions may not display after you
deactivate and activate the pim protocol. This is a cosmetic issue and there is no
interruption to the multicast traffic flow. [PR/419509]
■
Setting the advertise-high-metric option while using IS-IS overload also suppresses
route leaking. [PR/419624]
■ On JUNOS OSPF, all locally generated Type 5 LSAs are purged and regenerated
while deleting an NSSA area from the area border router (ABR). [PR/457579]
■ When aggregate interfaces are used for VPN applications, load balancing may
not occur with a Layer 2 circuit configuration. [PR/471935]
■ During transient periods where both a secondary and primary LSP exist in a
routing table, and the number of LSP NHs is greater than 16 in a multigateway
scenario, IS-IS may remove the preferred LSP NH. For example, IS-IS could
remove an HIPRI LSP. [PR/485748]
Issues in JUNOS Release 10.1 for M Series, MX Series, and T Series Routers ■ 61
Issues in JUNOS Release 10.1 for M Series, MX Series, and T Series Routers

Juniper JUNOS 10.1 - RELEASE NOTES REV 4 Specifications

General

Brand	Juniper
Model	JUNOS 10.1 - RELEASE NOTES REV 4
Category	Software
Language	English