does not detect the attack on the non-standard port (for example, junos:ftp on
port 85). [PR/477748]
■ In the export version of the JUNOS Software, the signature download does not
work for AppID and IDP features in the Dynamic Application Awareness (DAA)
suite. In order to resolve this, install the Crypto software suite. [PR/499395]
■ L2tpd asserts when short length frames are sent. This causes the l2tpd to crash.
As per RFC 1661 and 1662, such packets should be treated as invalid and
discarded. [PR/533057]
Subscriber Access Management
■
The revert-interval value configured in the [edit access profile] hierarchy level is
ignored. [PR/454040]
■ The RADIUS accounting stop messages do not include the Acct-Terminate-Cause
attribute (type 49). [PR/458034]
■ For a dynamic PPPoE interface in which the subscriber is assigned to a
non-default routing-instance (via the LSRI-Name or redirect-LSRI-Name RADIUS
VSAs), the IP address assigned to the subscriber must be specified via the
framed-ip-address RADIUS attribute. An IP address can not be allocated from a
local pool defined in the assigned routing-instance, either when RADIUS returns
no address attributes or when the RADIUS framed-pool attribute is returned.
[PR/471677]
■
The destination and destination-profile options for address and
unnumbered-address within the family inet and inet6 are allowed to be specified
within a dynamic profile, but are not supported. [PR/493279]
User Interface and Configuration
■
When the allow-command show interfaces $ is set in the class definition (specified
inside a user configuration), the user is unable to access any commands that
begin with show. [PR/55413]
■ Deletion of configuration groups cannot be prevented with the allow-configuration
and deny-configuration statements. [PR/59187]
■ On M20 routers, after a Routing Engine mastership switchover, it might not be
possible to enter CLI configuration mode on the new master Routing Engine.
Also, the request system reboot and request system halt commands do not clearly
fail but do not return the CLI prompt either. [PR/64899]
■ The JUNOScript perl module for NETCONF does not support configuration-text.
[PR/82004]
■ "Local Password:" is prompted even though the authentication order has the
password configured. [PR/94671]
■
When the CLI screen length is set to zero and the show log command is used,
the “more” prompt ignores the CLI screen length of zero, and only a fraction of
the number of lines is displayed. [PR/103595]
Issues in JUNOS Release 10.1 for M Series, MX Series, and T Series Routers ■ 63
Issues in JUNOS Release 10.1 for M Series, MX Series, and T Series Routers
To Next Page
Loading...
Need help?
General
