Juniper JUNOS 10.1 - RELEASE NOTES REV 4 User Manual

■ The logical system administrator can modify and delete master administrator-only
configurations by performing local operations such as issuing the load override,
load replace, and load update commands. [PR/238991]
■
The “replace:” tag is missing from the output of the save terminal command from
inside a configuration object.
Example:
edit system
save terminal
system {
host-name blue;
}
[PR/269736]
■ The user can still commit an invalid configuration successfully, even when DDL
checks exist. [PR/282896]
■ After AI scripts are added, the existing management sessions (including the one
used to add the AI scripts) must exit the edit mode and reenter it for any
subsequent configuration changes to take effect. Changes made in these existing
edit sessions are not written to the candidate configuration. [PR/297475]
■ A user class configuration with a deny command ".*" returns a .noop error when
the Return key is pressed on the router’s CLI. As a workaround, replace "^$"
with "^.noop-command$" in allow regex, i.e., allow-commands "(show
interfaces)|(show route)|(exit)|(^.noop-command$)";. [PR/311426]
■ On M Series, MX Series, and T Series routers, the user cannot differentiate
between active and inactive configurations for system identity, management
access, user management, and date and time pages. [PR/433353]
■ Selecting the monitor port for any port in the Chassis Viewer page displays the
common Port Monitoring page instead of the corresponding Monitoring page of
the selected port. [PR/446890]
■ J-Web does not display the USB option under Maintain>Reboot>Reboot from
the media. [PR/464774]
■ On MX Series routers, J-Web does not display the USB related information under
Monitor>SystemView>System Information>Storage. [PR/465147]
■ On M7i and M10i routers with Enhanced CFEB installed, the chassis viewer
plug-in does not display the Routing Engine in the front view and the E-CFEB in
the rear view. However, the chassis contents from the system (left side tab)
display the list of components correctly. [PR/483375]
■ Using the new-line character \n within op script argument descriptions will cause
the help output to be displayed incorrectly and could result in extra output being
displayed when the op script runs. [PR/485253]
■
In the J-Web interface, the options Access Concentrator, Idle Timeout, and Service
Name for PPPoE logical interfaces are not supported on MX Series routers.
[PR/493451]
■ On J-Web, the error message: “Fatal error: Allowed memory size..." displays
when the Interfaces tab is selected. This message also displays when the
Interfaces tab under Class-of-Service is selected. [PR/495825]
64 ■ Issues in JUNOS Release 10.1 for M Series, MX Series, and T Series Routers
JUNOS 10.1 Software Release Notes

Juniper JUNOS 10.1 - RELEASE NOTES REV 4 Specifications

General

Brand	Juniper
Model	JUNOS 10.1 - RELEASE NOTES REV 4
Category	Software
Language	English