version for client interfaces. The following example provides the appropriate
syntax for setting the IGMP interface to obtain the IGMP version from RADIUS:
[edit dynamic-profiles access-profile protocols igmp interface $junos-interface-name]
user@host# set version $junos-igmp-version
■ The Subscriber Access Configuration Guide and the System Basics Configuration
Guide contain information about the override-nas-information statement. This
statement does not appear in the CLI and is not supported.
[Subscriber Access, System Basics]
■ When you modify dynamic CoS parameters with a RADIUS change of
authorization (CoA) message, the JUNOS Software accepts invalid configurations.
For example, if you specify that a transmit rate that exceeds the allowed 100
percent, the system does not reject the configuration and returns unexpected
shaping behavior.
[Subscriber Access]
■ We do not support multicast RIF mapping and ANCP when configured
simultaneously on the same logical interface. For example, we do not support
when a multicast VLAN and ANCP are configured on the same logical interface,
and the subscriber VLANs are the same for both ANCP and multicast.
[Subscriber Access]
■ The Guidelines for Configuring Dynamic CoS for Subscriber Access topic in the
Subscriber Access Configuration Guide erroneously states that dynamic CoS is
supported for dynamic VLANs on the Trio MPC/MIC family of products. In the
current release, dynamic CoS is supported only on static VLANs on Trio MPC/MIC
interfaces.
[Subscriber Access]
■ The Subscriber Access Configuration Guide incorrectly describes the
authentication-order statement as it is used for subscriber access management.
When configuring the authentication-order statement for subscriber access
management, you must always specify the radius method. Subscriber access
management does not support the password keyword (the default), and
authentication fails when you do not specify an authentication method.
[Subscriber Access]
■ In the JUNOS Subscriber Access Configuration Guide, Table 26, “RADIUS-Based
Mirroring Attributes” incorrectly indicates that RADIUS VSA 26-10,
Juniper-User-Permissions, is required for subscriber secure policy mirroring. In
fact, this VSA is not used.
[Subscriber Access]
96 ■ Errata and Changes in Documentation for JUNOS Software Release 10.1 for M Series, MX Series, and T Series Routers
JUNOS 10.1 Software Release Notes
To Next Page
Loading...
Need help?
General
