Juniper MX10004 - Page 11

You can use group-name as re0 or re1.
[edit]
root@# set groups group-name interfaces em0 unit 0 family inet address address/prefix-length
For Example:
[edit]
root@# set groups re0 interfaces em0 unit 0 family inet address address/prefix-length
[edit]
root@# set groups re1 interfaces em0 unit 0 family inet address address/prefix-length
10. (Oponal) Congure the stac routes to remote prexes with access to the management port.
[edit]
root@# set routing-options static route remote-prefix next-hop destination-ip retain no-readvertise
For example:
[edit]
root@# set routing-options static route 192.168.0.0/24 next-hop 10.0.3.2 retain no-readvertise
11. (Oponal) Enable Telnet service.
[edit]
root@# set system services telnet
NOTE: When Telnet is enabled, you cannot log in to an MX10004 through Telnet using root credenals.
Root login is allowed only for SSH access.
12. (Oponal) If you used one or more conguraon groups, apply the conguraon groups, substung the
appropriate group name.
[edit]
root@# set apply-groups group name
11