Juniper MX10004 - What Else Do I Need?; Assemble the Rack Mount Kit

What Else Do I Need?
• A mechanical li rated for 250 lb (113.4 kg). You can mount an MX10004 router manually or by using a mechanical
li. Because of the router's size and weight, we strongly recommend that you use a mechanical li to mount the
MX10004. In this guide, we show you how to mount the router using a mechanical li.
• 4 AWG (21.1 mm²) stranded wire grounding cable rated 75° C or per local electrical code
• A Phillips (+) screwdriver, number 2 or number 3, depending on the size of your rack-mount screws
• Twenty eight rack mount screws appropriate for your rack to secure the mounng blades, mounng tray, chassis,
and safety restraint to the rack
• A number 3 Pozidriv or Phillips (+) screwdriver for the grounding screws
CAUTION: Ensure that a licensed electrician aaches the appropriate grounding lug to your grounding
cable. Using a grounding cable with an incorrectly aached lug can damage the router.
Assemble the Rack Mount Kit
Here's how to assemble the MX10004 rack-mount kit in a four-post rack:
1. Review the General Safety Guidelines and Warnings.
2. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other end to a site
ESD point.
3. Aach the mounng blades to the front rack posts by using six rack mount screws.
4. From the rear of the rack, slide the mounng tray into the rear posts of the rack such that the mounng blades slide
into the grooves on the mounng tray.
3