Juniper MX10004 - Mount the MX10004 in the Rack and Ground the Chassis

5. Aach the mounng tray to the rear rack posts by using eight rack mount screws.
6. Check that the mounng tray is level.
7. Aach the mounng tray to the mounng blades in the rack with the 12 Phillips 8-32 x .375 in. at-head screws.
Mount the MX10004 in the Rack and Ground the Chassis
Here’s how to install the MX10004 in a four-post rack:
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other end to a site
ESD point.
2. Load the router onto the li, making sure it rests securely on the li plaorm.
4