Juniper MX10004 - Page 5

3. Align the router in front of the rack, centering it in front of the mounng tray.
4. Li the chassis approximately 0.75 in. (1.9 cm) above the surface of the mounng tray. Align the chassis as close as
possible to the mounng tray.
5. Carefully slide the chassis onto the mounng tray unl the chassis anges touch the rack rails.
6. Starng at the boom, aach the chassis to the rack by inserng eight rack mount screws through each open
ange hole and rack hole.
7. Move the li away from the rack.
8. Check the alignment of the router. The rack mount screws on each side of the rack should line up, and the router
should be level. Tighten the screws.
9. Insert the safety restraint between the rear posts of the rack. It should rest on the top of the chassis and align with
the holes in the rack.
10. Aach the restraint to the rack by inserng six mounng screws through each ange hole and rack hole and
ghtening the screws.
5