To install the router transport kit:
1. Remove the router transport kit from the shipping crate (see “Unpack the Router
Transport Kit” on page 28).
NOTE: The router transport kit weighs approximately 138.5 lb (62.82 kg).
2. Remove the winch strap plate that is secured to the winch mount by using a
9/16-in. (14 mm) socket wrench, and set the plate aside.
3. Using a number 3 Phillips screwdriver, loosen the captive screws that secure the winch
mount to the router transport kit, and set the mount aside.
4. Using a number 3 Phillips screwdriver, loosen the captive screws that secure the router
transport mounting plate and wheel assembly (left and right) to the router transport
platform, and set them aside (see Figure 20 on page 31).
Figure 20: Preparing the Router Transport Kit for Installation
5. Remove the four shipping brackets that secure the router to the shipping crate platform
by using a 9/16-in. (14 mm) socket wrench, and a number 2 Phillips screwdriver, and
set the brackets aside.
6. Align the left router transport mounting plate and wheel assembly (indicated by left
arrow) with the holes on the left side of the chassis (see Figure 21 on page 32).
7. Using a number 3 Phillips screwdriver, tighten the captive screws to secure the router
transport mounting plate and wheel assembly to the chassis.
31Copyright © 2015, Juniper Networks, Inc.
Install the Router Transport Kit onto the Router
To Next Page
Loading...
Need help?
General
