Juniper QFX5100-48S - User Manual

Quick Start Guide
QFX5100-48S
IN THIS GUIDE
Step 1: Begin | 1
Step 2: Up and Running | 4
Step 3: Keep Going | 6
Step 1: Begin
IN THIS SECTION
Mount the QFX5100-48S | 2
Connect Power to the Switch | 3
To install and configure a Juniper Networks QFX5100-48S Switch, you need:
•
Electrostatic discharge (ESD) grounding strap (not provided)
•
One pair of front mounting-rails (provided)
•
One pair of rear mounting-blades (provided)
•
Twelve screws to secure the mounting-rails and mounting-blades to the chassis (provided)
•
Eight screws to secure the chassis and mounting-blades to the rack (not provided)
•
Screwdriver appropriate for your rack mounting screws (not provided)
•
Two power cords with plugs appropriate for your geographical location (provided)
•
RJ-45 cable and RJ-45 to DB-9 serial port adapter (provided)

Juniper QFX5100-48S Specifications

General

Brand	Juniper
Model	QFX5100-48S
Category	Switch
Language	English

Summary

Step 1: Begin

Mount the QFX5100-48 S

Guide on physically installing the QFX5100-48S switch into a four-post rack configuration.

Connect Power to the Switch

Instructions for connecting the QFX5100-48S switch to AC power using provided cords.

Step 2: Up and Running

Set Parameter Values

Specifies the required serial console parameter values for initial switch configuration.

Perform the Initial Configuration

Details the steps to connect to the switch console and perform initial CLI configuration.

Step 3: Keep Going

Safety Warnings Summary

Provides a summary of safety warnings for installing and servicing the QFX5100-48S switch.

Power Cable Warning

Specific warning regarding the use of the provided power cable for this product only.

Contacting Juniper Networks

Information and URL for obtaining technical support from Juniper Networks.