To Next PageTo Next PageWhat to do if my Juniper Gateway is not receiving power?
If your Juniper Gateway isn't receiving power, check the following: * Make sure the AC power cord connecting the power source to the device isn't damaged. Replace it immediately if the insulation is cracked or broken. * Confirm that the power socket you're using is working correctly. * Verify that the device's AC input voltage is between 100 and 240 VAC.
Why is my Juniper Gateway chassis too warm?
If the Juniper Gateway chassis temperature is too warm, check the room temperature. Refer to the “SRX340 Services Gateway Environmental Specifications” on page 32 for recommended temperature ranges.
How to fix Juniper Gateway booting from alternate boot device?
If the internal flash memory fails when starting your Juniper Gateway, the device automatically boots from the alternative boot device (USB storage device). If you have configured your services gateway to boot from an alternative boot device, you can ignore this alarm. Otherwise, reformat the internal flash memory and install a bootable image. Consult the Software Installation and Upgrade Guide and Network Management and Monitoring Guide for instructions. If you have not configured the services gateway to boot from an alternative boot device, contact JTAC.
What happens if Juniper SRX340 temperature is too high?
If the Juniper Gateway temperature gets too high due to internal overheating or exceeding the maximum recommended room temperature, the services gateway will automatically shut down in 4 minutes.
General| Firewall Throughput | 3 Gbps |
|---|---|
| Maximum Concurrent Sessions | 256, 000 |
| Memory | 4 GB |
| Redundant Power Supplies | No |
| Operating Temperature | 32°F to 104°F (0°C to 40°C) |
| Humidity | 10% to 90% non-condensing |
| Storage | 8 GB |
