Juniper SRX340 How To Set Up

How to Set Up Your SRX300 Services Gateway
6
3. Configure the basic settings:
a. Device name
b. Password for the root account
c. Time
4. Configure the security topology:
a. Internet zone
b. Internal zones
c. DMZ
5. Configure the security policy:
a. Licenses
b. DMZ policy
c. Internal policy
d. Remote access
6. Configure Network Address Translation:
a. Source NAT
b. Destination NAT
7. Review the settings and click Apply Settings.
NOTE: Check the connectivity from the management device to the SRX
Series device. You might lose connectivity to the SRX Series device if you
have changed the management zone IP. Click the URL for reconnection
instructions on the Confirm & Apply page to reconnect, if required.
8. Click Done to complete the setup.

Juniper SRX340 Specifications

General

Firewall Throughput	3 Gbps
Maximum Concurrent Sessions	256, 000
Memory	4 GB
Redundant Power Supplies	No
Operating Temperature	32°F to 104°F (0°C to 40°C)
Humidity	10% to 90% non-condensing
Storage	8 GB