Juniper SRX340 - Page 6

How to Set Up Your SRX340 Services Gateway
6
4. Configure the security topology:
a. Internet zone (Untrust)
b. Internal zones (Trust)
c. DMZ
5. Configure the security policy:
a. Licenses (Security services)
b. DMZ policy
c. Internet and internal policies
d. Remote VPN
6. Configure Network Address Translation:
a. Internal Source NAT
b. Internal Destination NAT
c. DMZ Destination NAT
7. Review the settings and click Apply Settings.
NOTE: Check the connectivity from the management device to the
SRX Series device. You might lose connectivity to the SRX Series device
if you have changed the management interface IP. Click the URL for
reconnection instructions on the Confirm & Apply page to reconnect,
if required.
8. Click Done to complete the setup.