SERVICE LED, one tricolor
•
Green–The SPC is running under acceptable load.
•
Amber–The SPC is overloaded.
•
Red–No service is being provided by the SPC.
•
Off–The SPC is not enabled.
OK/FAIL LED, one bicolor:
•
Steady Green–The SPC is operating normally.
•
Blinking Green–The SPC is preparing for hot-swap event.
•
Red–The SPC has failed and is not operating normally.
•
Off–The SPC is powered down.
LEDs
The SPC serial number label is located as shown in Figure 2 on page 7).
Figure 2: SPC Serial Number Label
g036081
S
R
X3K-SPC-1-10-40
Serial number
label
Serial Number
Location
Related
Documentation
SRX1400, SRX3400, and SRX3600 Services Gateway Module Overview on page 2•
• Modules Supported on SRX1400, SRX3400, and SRX3600 Services Gateways on
page 3
• Eligible Slots for SRX1400, SRX3400, and SRX3600 Services Gateway Modules on
page 4
• Installing Common Form Factor Modules In SRX1400, SRX3400, and SRX3600 Services
Gateways on page 22
7Copyright © 2016, Juniper Networks, Inc.
Services Processing Card SRX3K-SPC-1-10-40
To Next Page
Loading...
